Belt wrist cuff

You will need

• A belt
• Scissors or a razorblade
• needle and thread
• Pliers(optional)
• A seam ripper(a razorblade or knife can be used instead>

Step 1

Cut belt to size of wrist using scissors or a razor blade anything you got on hand tbh.

Step 2

Get the buckle of the belt again cut using anything you can get through the belt with.

Step 3

If the belt has a seam here cut it open, you will be sewing your own seam in a second. If you don't have a seam ripper you can use a razor blade just be careful!

Step 4

sandwich the belt part with the holes between the buckle and sew a new seam,i used a classic straight stitch and some pliers to drive the needle through the belt, this will hold your wrist band together so take your time!

You will need

• Pliers
• Safety pin
• Beer top
• Can tab

Step 1

Bend the can tab with the pliers to look like a 'V' and try to flatten out the ends.

Step 2

put the tab into the beer top and start flattening the edges with the pliers

It should look like this

Step 3

Stuff a safety pin into the can tab and bam you're done! This is a super fun and simple craft that can add to anything! I have some on my patch pants and ofc the one on my guitar case.